Earthquaker Avalanche Run V2

This item is new, in box!

From Earthquaker:

Jacks & Signal Path:
-To Run Mono: Use the left input and output only.
-To Run Stereo: Use both left and right inputs and outputs
-To Run Mono In and Stereo Out: Use the left input and both left and right outputs
-Cool Trick: Plugging into the right input and using the left and right outputs will give you an all-wet left channel and a standard mixed right channel while the effect is engaged. You can create dramatic stereo effects by keeping the Mix set low and turning up the amplifier source connected to the left output. The left output will not pass dry signal when the effect is turned off in true bypass mode but trails mode it will still produce the effected signal as long as it is set to decay.

Dimensions: 4.65 x 4.15 x 2.25 in. (118 x 105 x 57 mm) with knobs
Current Draw: 410 mA
Input Impedance: 1 MΩ
Output Impedance: 100 Ω
S/N Ratio: 115dB typical
24-bit 96kHz A/D & D/A converters
All analog dry signal path
All digital wet signal path with 20Hz – 20kHz frequency response

Expression Jack
The expression jack is located on the west side of the pedal. It is a TRS jack with the tip acting as the wiper. 
We recommend using a Moog expression pedal with the output adjustment knob all the way up.
We cannot guarantee any other expression pedal to work with the Avalanche Run.

Flexi-Switch Technology
This  device features Flexi-Switch Technology! This relay-based, true bypass  switching style allows you to simultaneously use momentary and latching  style switching.
For standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass.
For  momentary operation, hold the footswitch down for as long as you’d like  to use the effect. Once you release the switch the effect will be  bypassed.
Since the switching is relay based, it requires power to pass signal.

Power
For best results, please use the included 9v center-negative 1-amp DC power supply.